I've been using this mod for better part of 6 months so far and I LOVE it. It has a DNA40 Chip in it. Meaning it has the capability of going from 1w all the way to 40w. It also has a 200* to 600* temp control setting that allows you to control the temp of your vaping.
Temp control MODS Needs Titanium or Nichrome 200 Wire. I use a 26g Ni200 Wire for my MOD. I use this mainly on my Plume Veil v3 Dripper because it burns so hot that the tank can't keep up with the juice requiremnts.
I build my Coil with my Kuro Coil Building Kit. Ranging from 1.0mm all the way to 3.5mm in Inside Diameter, Depending on the Ohm of the coil will determin how many wraps. And since this is a Sub Ohm, Meaning anything below 1.0 Ohm is Sub Ohm. My Coils need to be built to around .17 Ohm which is the Lowest my MOD will accept for a coil in Temp control.
This would be 12 wraps on a 3.0mm I.D. Rod. The coils also need to be seperated about 1/64th apart basically none of the coils touching each other. Then wicked with Cotton and saturated with your eLiquid of choice.
This MOD Also uses a Single 18650 Rechargeable Battery. I Keep 2 on Hand, while Vaping on one, the other is charging, then swap out once one is dead for the newly recharged one.
On my MOD, I use a Kangertech Sub Ohm Mini Tank which holds around 4.5ml of eLiquid. It has a Mini RDA (Rebuildable Adamizer) which is a Money Saver. I don't have to purchase coils, I can build my coil on my RDA, wick it, juice it and Vape it. I think it's the BEST Tank that I've purchased. eBay has these tanks for $20.00 which is a GREAT Deal considering most of them are around $50.00.
I think I about covered the Post for today on my Gr-Star, I'll be posting a photo later on of my MOD, I'm going to Post a Few Photos on some Coil builds as well. After all this is a This and That Blog, so I'll cover just about everything!.
No comments:
Post a Comment